XMAX V3 Pro Capacity: How Much Fits in the Chamber?
Teilen
The XMAX V3 Pro chamber holds about 0.15 g of ground dry herb. Retailer specifications and reviews give the V4 Pro as roughly 0.1 to 0.15 g, with about 0.2 g as a practical maximum if you fill it loosely. The manufacturer's manuals do not state a figure for either model, but they do tell you to pack loosely and never let the herb go above the top of the oven. The ceramic-oven Starry 4 is different: the maker's FAQ gives its oven capacity as about 1.35 ml.
This guide is about capacity only. For step-by-step use, see how to use the XMAX V3 Pro and V4 Pro, and for the differences between the models see V3 Pro vs V4 Pro vs Starry 4. More guides are in the XMAX hub.
- The capacity numbers
- Why the chamber is small
- How to fill it
- What one chamber gives you
- Dosing capsules
- Accessories
- Cleaning between loads
- Quick answers
1. The Capacity Numbers
| Model | Chamber | Stated capacity | Source |
|---|---|---|---|
| XMAX V3 Pro | Stainless steel | About 0.15 g | Retailer specifications and reviews |
| XMAX V4 Pro | Stainless steel | About 0.1 to 0.15 g, about 0.2 g at most | Retailer specifications |
| XMAX Starry 4 | Ceramic | About 1.35 ml | Manufacturer's FAQ |
The V3 Pro and V4 Pro figures come from retailers and reviewers who weighed their own loads, so treat them as typical rather than guaranteed. A volume in millilitres is not published for those two models, so we do not quote one. Capacity also depends on the grind and on how much you tamp, and a fluffy medium grind will weigh less than the same chamber packed down.
2. Why the Chamber Is Small
Both models use a convection design, where hot air passes through the herb rather than the herb being pressed against a hot wall. Reviewers point out that the small load is what lets the device stay slim and heat up in seconds, and that it also means heavier users will reload often. One review calls the chamber "extremely small" and says it limits session length. The manuals agree on the airflow principle: the maker's support pages advise packing the chamber loosely so that air can flow through the herb during convection heating.
3. How to Fill It
- Use a medium grind. Fine enough to expose the surface, coarse enough that air can pass through.
- Pack loosely. The V3 Pro and V4 Pro manuals ask you not to let the herb go beyond the top of the oven chamber, and to be gentle when packing the oven.
- Do not press the herb down. A retailer guide suggests filling the V4 Pro loosely to about half the chamber, never above the rim, and never pressing it, because convection needs air to move through the load.
- Keep the screen clean. A clogged mesh screen at the bottom of the chamber restricts airflow. See our screens and filters guide.
4. What One Chamber Gives You
The manuals give the session timers as 4 or 6 minutes. In on-demand mode the heater runs only while you hold the power button. The manuals do not say how many draws one load gives, and neither do we: it depends on temperature, how the chamber is packed and how you draw. For battery details, see our battery guide.
5. Dosing Capsules
The V4 Pro and Starry 4 manuals describe a dosing capsule: you open the capsule, load it, and drop it into the oven chamber. A retailer states that capsules for the V4 Pro hold about 0.1 to 0.15 g and keep the chamber cleaner, though airflow tightens slightly with a capsule in place. Vapetrix does not currently list XMAX dosing capsules, so we cannot link any.
6. Accessories
Capacity is set by the oven, but the mouthpiece changes how the session feels. The 60 mm short shaded black stem is compact for carrying and the 110 mm long straight stem gives a longer vapor path. Both fit the V3 Pro and V4 Pro. Browse the XMAX V3 Pro and V4 Pro accessories collection for the full range.
7. Cleaning Between Loads
A clean chamber and screen keep airflow even from one load to the next. The V3 Pro and V4 Pro manuals both recommend cleaning all parts that touch the herb or vapor regularly, and they say every removable part can be taken apart for cleaning. The routine they describe is:
- Mouthpiece or cap and filter: pull it off gently. The manuals say it can be cleaned with soap and water. The V3 Pro manual specifies that the plastic cap should not go in isopropyl alcohol.
- Deep clean: immerse the pieces in isopropyl alcohol for 10 to 20 minutes, rinse thoroughly with clean water, and dry before reassembling.
- Metal oven: sweep the inside with the brush, then wipe with a cotton swab dipped in isopropyl alcohol.
- Burn off: after cleaning, the manuals suggest running a burn-off cycle at the maximum temperature for 2 minutes.
- Replacing the oven mesh screen: slowly lift the old screen out along the wall of the oven with the cleaning tool, put the new one in, and press it into position with the cleaning tool.
The manuals also say not to clean the whole device with water or submerge it, not to inject any liquid or oil into the metal oven, and not to touch the heating element straight after use. Let the device cool before you store it in a clean, dry place.
The cleaning kit is in the box. The V4 Pro manual lists a brush, three cotton swabs, four alcohol cotton pads, a cleaning tool and four mesh screens, and the V3 Pro manual lists the same cleaning items with two mesh screens. That is why the screen swap above does not need extra parts. For loading steps in more detail, see our how-to guide.
8. Quick Answers
Can I overfill it for a longer session? It is not a good idea. The manuals say not to let the herb go above the top of the oven chamber, and an overfilled chamber restricts the airflow that convection depends on. You will get thinner vapor, not more.
Is the V4 Pro chamber bigger than the V3 Pro's? Not according to the published figures: both sit at roughly 0.1 to 0.15 g, with 0.15 g quoted for the V3 Pro. On those figures, capacity is not a reason to pick one over the other; features such as airflow control are. Our naming guide sets them side by side.
Does the temperature change how long a load lasts? The manuals do not give a figure, and in practice it depends on the temperature, how loosely you pack and how you draw. Our how-to guide covers the temperature controls.
Do I need to weigh my loads? Not necessarily, but a small scale is the only way to know your own figure, because grind and tamping change it. Judge by the chamber: filled loosely and below the rim.
Final Thoughts
Plan on about 0.15 g for the V3 Pro and about 0.1 to 0.15 g for the V4 Pro, fill loosely with a medium grind, and keep the herb below the top of the chamber. The Starry 4's ceramic oven is a different size, at about 1.35 ml. If you want long sessions, expect to reload, and keep the screen clean so every load gets proper airflow.



